3671N Jenco Controller

1/8 DIN panel mount pH/ORP controller with dual SPDT Hi/Lo relays, manual set points and calibration are via potentiometers. Features a voltage/recorder output and an internal pH/ORP select switch. Display is a large bright red LED. Connectors are a BNC input and spade lug screw type connector block. Meter requires a Pt-100 ATC or a simulation resistor for temperature. Power115/230A AC.

• All Solid State Design 
• Low Cost 
• Easy To Install 
• Set Points On Front Panel 
• Recorder Output 
• 0.56 High Efficiency Red LED Display 
• 1/8 DIN Aluminum Case 
• Set Points Cover Entire Span 
• ATC For pH 0 To 100 °C 
• Internal pH/Orp Select Switch 
• Low Power Consumption Design, Reduced Internal Heating Thus Increased Reliability